A great day for all man kind!
A corner was turned.
Yes folks you guessed it...
BAH-BAH-BAHAHAAAAAH...
Project Grover Rover has commenced the rebuild!!
YIIPP-YIPPY-DOO-DIDDLY-DEEE-DAH!!! =D
With the combined brain power of Dodgy Dan, Bush
Tucker Dad, and Oober Nerd himself, today were
going to build a Grover!
With a couple of death knots hanging the chassis from a water pipe, we had Grovers ass in the air ready to recieve springs.
"Permission to scratch Grover" shouts Dan, holding a large hammer. We knew what needed to happen... I Nodded.... *WHUMP*WHUMP*WHUMP* And the springs were driven home.
After a short debate over which bolt goes where, air tools drove them home.
Lifting the engine was a breeze with the Lever Hoist I splurged on.
If only the garage was taller.
We couldn't quite lift the engine high enough.
So, with a rug over the chassis, we man handled the engine in place.
*S-C-R-A-A-A-T-C-C-C-H*
=( Oh well, had to happen eventually.
The next few hours were filled with me searching the garage for bolts and washers but in the end, Grover is finally a rolling chassis once more. Thanks Dan, Yer a bloody legend!! =D
No comments:
Post a Comment